Cooper DF6000 Instrukcja Użytkownika Pobierz pdf (Strona 4)

SOFTWARE UPDATES

• Font no longer reset after screen calibration.

• Fixed bug on "go to" screen, if you did not select a loop it would not work, loop now defaults to 1.

• Buzzer beeps only when user hits a control that does something, rather than when they touch the

screen.

• Fixed bug where the level 1 "Accept ﬁre" button was not working, it was going to another screen.

• Fixed bug in sending pre-alarm across network, type was not being sent.

• Fixed bug in detecting when a zone had become disabled by disabling all its devices.

• Fixed bug in printing of panel disablements (FRE, FPE, sounders).

• Fixed bug displaying panel number of the analogue value screen.

• Fixed bug displaying the enable/disable status of sounders on the level 2 menu.

• Analogue level test function importing wrong fault values for heat devices, causing heats to fault with

value <10.

• Fixed a bug in the “Disable –All” menu 130170.

• Fixed a problem with list of zones, if there is a gap, it does list all zones.

• Fixed a problem with Australian FB screen as it would always initially show disabled address count as

• MCOM devices on loop4 activated by zones outside of populated list, sub address indexer not re-

initialised for loop driver 2 downloadh

• “Auto conﬁg” not locating ID mismatches.

CF3000 / DF6000 / FX6000

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Cooper DF6000 Instrukcja Użytkownika Strona 4