Cooper i-On 40 Instrukcja Użytkownika Pobierz pdf (Strona 6)

9. Push the interface cable terminal connector into an

open accessory jack on the side of the control panel

(on CL-6 controls, the hinge side). Use the lower jack,

Com 2, unless it is already in use. See Figure 6.

10. Use the supplied Nylon cable clip, route the control

cable through the clip and mount the clip to the control

using the threaded hole adjacent the accessory jacks.

See Figure 6.

11. Route the cable along the back of the control panel and

add cable ties where appropriate.

12. Set the DIP switch setting.

Ethernet Communication Module

A. Fiber communication set the DIP to Fiber position

B. Copper communication set the DIP to the Copper

position

Installing Ethernet Card in Non-

Cooper Control Cabinets

Follow the steps below when mounting the communication

module to a CL-6B series control which is in an enclosure

from a manufacturer other than Cooper Power Systems.

1. De-energize the control panel according to the regulator

manufacturers’ instructions.

2. The communications board may be mounted at two

possible locations on the rear of the CL-6B control

panel. Each location is defined by four threaded

mounting holes. Locate one set of four mounting holes

on the rear of the CL-6B control panel. See Figure 8.

Choose the set of mounting holes that best fits the

space available in the cabinet.

3. Screw the 1/2" threaded stand-off studs into the rear of

the CL-6B control panel. See Figure 8.

4. Go to Step 4 (on page 2) to continue the installation

process.

Ethernet Communications Module Installation and Operation Instructions

Figure 7.

Ethernet Communication Module.

Figure 8.

Stand-off studs on control panel.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Brak uwag

Cooper i-On 40 Instrukcja Użytkownika Strona 6