Cooper TS590 Instrukcje Operacyjne Pobierz pdf (Strona 36)

Fault Finding

Display Messages

Displays Description

There is no mains power to the control panel and the alarm system is now

running on its standby battery. The system will also generate a chime tone

every minute to warn you that the fault exists, to silence the chime tones

simply enter your passcode. If the mains power is not restored you may not

be able to set the alarm system. If the fault persists the standby battery will

eventually run flat. Contact your alarm company for further advice.

A full alarmhas occurred from a detection circuit (circuit 05). This message

is normally display after unsetting the alarm system. Before the system can

besetagainthealarmsystemmustbereset,see“ResettingAfteranAlarm”

on page 10.

Anauxiliaryalarmhasoccurredfromadetectioncircuit(circuit06).Thetype

ofalarmissilentandwillactivatetheappropriateoutputs.Toresetthealarm

simply enter your passcode followed by [ESC].

Thecontrolpanelauxiliaryorbelltampercircuitshavebeenactivated.Ifthe

faultisnotclearedyouwillnotbeabletosetthealarmsystem.Tosilencethe

alarmsimplyenter yourpasscode. Contactyouralarmcompanyforfurther

advice.

Thealarmsystemstandbybatteryhasdevelopedafault,normallybecause

the system mains power is not present. If the fault is not cleared you will not

be able to set the alarm system. To silence the alarm simply enter your

passcode. Contact your alarm company for further advice.

One or more circuits have been isolated from the system. For full details

refer to “Isolate / Re-Instate Shunt Group” on page 18.

Apasscodehas beenincorrectly enteredmore thanfourtimesata remote

keypad (keypad 02). To silence the alarm enter a correct passcode. To

reset the alarm simply enter your passcode follows by [ESC].

A delayed full alarm has occurred from a detection circuit (circuit 05). This

message is normally display after unsetting the alarm system. Before the

system can be set again the alarm system must be reset, see “Resetting

After an Alarm” on page 10.

An entry time out alarm has occurred from a detection circuit (circuit 01).

Thisisnormallycausedwhentheentryprocedureisstartedandthesystemis

not unset before the timer expires. Before the system can be set again the

alarm system must be reset, see “Resetting After an Alarm” on page 10.

DELAY ALARM 05

17:30 01 Jan

DELAY ALARM 05

17:30 01 Jan

AC OFF

17:30 01 Jan

AUX/BEL TAMPER

17:30 01 Jan

BATTERY FAULT

17:30 01 Jan

CCTS ISOLATED

17:30 01 Jan

ALARM 05

17:30 01 Jan

AUXILIARY 06

17:30 01 Jan

CODE TAMPER 02

17:30 01 Jan

DELAY ALARM 05

17:30 01 Jan

CODE TAMPER 02

17:30 01 Jan

ENTRY ALARM 01

17:30 01 Jan

1 2 ... 31 32 33 34 35 36 37 38 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Cooper TS590 Instrukcje Operacyjne Strona 36

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Cooper TS590