Cooper DF6000 Instrukcja Użytkownika Pobierz pdf (Strona 17)

DF6000 - USER MANUAL

Micro Interfaces

A range of micro interfaces modules are also available:

MCIM

Is a competitively priced input module, designed to enable a Menvier panel to accept input signals from

external devices such as key switches and sprinkler ﬂow switches. It is extremely compact

and therefore ideal for incorporation into other equipment. The maximum number of addressable MCIM per

loop is 20.

MCOM

Is a competitively priced output module, designed to enable a Menvier panel control external devices such

as door holders or access control systems. It is extremely compact and therefore ideal for incorporation

into other equipment. The maximum number of addressable MCOM per loop is 20.

MIU872

Is a compact single zone input, soft addressed, microinterface, incorporating integral short circuit isolators.

It is fully compatible with the current range of Menvier analogue ﬁre detection panels. It is suitable for

interfacing a zone of up to 20 conventional Menvier detectors onto a Menvier analogue ﬁre panel. It will

operate with any Menvier conventional detector in conﬁguration with a schottky diode type base.

MCIM-C (Identiﬁed as a Callpoint)

Is a compact input module used to accept input signals from external equipment such as beam detectors,

ﬂow switches, valve monitor switches etc. The maximum number of sounder devices per loop is 200.

MCOM-S (Identiﬁed as a Sounder)

Is a compact single channel output unit. This device is identiﬁed as a sounder output by a Menvier

addressable panel. The maximum number of sounder devices per loop is 60.

MCOM-R

Is a compact output module used to control or signal external equipment which require removal of power

for reset purposes. The maximum number of addressable MCOM-R per loop is 20.

MICM-NF

Is a compact single channel input unit. This device is identiﬁed as a non-ﬁre input module by the Menvier

addressable panel. The maximum number of addressable MICM-NF per loop is 200. Complex cause and

effect can still be achieved using the latest site installer software without any indication on the panel.

However the action will still be seen in the event log. Ideally suited for non ﬁre applications.

Section 1 - System Installation and Design

Micro interfaces

MCIM / MCOM / MIU872 / MCIM-C / MCOM-S / MCOM-R / MICM-NF

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 113 114

Brak uwag

Cooper DF6000 Instrukcja Użytkownika Strona 17